Luminous Anti-Slip Stair Tape

What this tape is

Luminous Anti-Slip Stair Tape is a black anti-slip tape with a green glow-in-the-dark stripe running down the middle. The top surface is coarse grit that gives shoes and bare feet something to grip. The tape is about 0.2 in (6 mm) thick, so it sits low on the step while still adding real texture underfoot.

The back is coated with adhesive. You peel the liner and press the tape onto a clean, dry step. The green stripe takes in light and glows in the dark, which helps the edge of a step stand out when the lights are low. Use it on stairs indoors and outdoors.

Sizes and pack options

One roll measures 2 in (5 cm) wide and 16 ft 5 in (5 m) long. That is enough to cover several treads or to run a strip along a landing, a ramp or a walkway. The tape comes in two pack choices.

Pick 2 rolls when you have a full flight of stairs or more than one area to cover. Pick 1 roll for a short set of steps, a single doorway or a spot repair.

Color and finish

The tape is black with a green stripe. The black grit hides scuffs and dirt well on busy steps, and the green stripe is the part that glows. The finish is matte and textured, not smooth, because the grit is what does the gripping.

Because the stripe glows, the tape reads clearly at night. That makes it a practical choice for basement stairs, garage steps, porch steps and any outdoor stair that sees traffic after dark.

Where to use it

This tape is made for stairs indoors and outdoors. Common spots include:

• Wood, concrete and metal steps
• Basement and attic stairs
• Porch, deck and garage steps
• Ramps, walkways and thresholds
• Boats, trailers and workshop areas

For outdoor use, apply it when the surface is dry and the temperature is mild. The adhesive bonds best to a surface that is free of dust, oil and loose paint.

How to apply it

1. Clean the step. Sweep off grit, then wipe with a damp cloth. Let it dry fully.
2. Measure and cut. Roll the tape out along the step and cut it to length with scissors or a utility knife.
3. Peel and press. Remove the backing a little at a time and press the tape down as you go.
4. Work out air bubbles. Push them toward the nearest edge with your thumb or a roller.
5. Let it set. Give the adhesive time to bond before heavy use.

For a straight run, mark a light pencil line first so the strip stays even. If you are covering a rounded nosing, press the tape over the curve in short sections rather than all at once.

Care and upkeep

Sweep or vacuum the tape along with the rest of the step. For a deeper clean, wipe it with a damp cloth and mild soap, then let it air dry. Avoid harsh solvents and abrasive scrubbing, which can wear down the grit and dull the glow stripe.

Check the edges now and then. If a corner lifts, press it back down while the adhesive is still tacky. In cold weather, the glow stripe may need a few minutes under bright light before it glows at full strength. Replace the tape when the grit is worn smooth or the stripe no longer glows.