Black Textured Anti-Slip Stair Tape

What this tape is

This is a roll of black anti-slip grip tape with an adhesive backing. The top face has a textured non-slip surface that gives shoes and bare feet something to grip. The tape is made for stairs and floors, and it works indoors and outdoors.

Each roll is 16.4 ft (5 m) long. You pick the width when you order: 1 in (2.5 cm) or 2 in (5 cm). One roll is in the box.

Sizes and options

Both widths come in black only. The 1 in (2.5 cm) width suits narrow step edges and small floor spots. The 2 in (5 cm) width covers more of the step and suits wider treads and busier areas.

Where to use it

Use this tape on steps and floor areas that need a non-slip strip.

Common spots:

• Stair treads at home, in a garage or on a porch
• Basement and deck steps
• Ramps and short slopes
• Kitchen, bathroom and entry floor areas
• Workshop and utility areas
• Boats, trailers and tailgates

Because the tape is made for indoor and outdoor use, it holds up on steps that see rain, sun or cold. The black color blends with dark treads and reads as a clear safety strip on light ones.

How to apply it

1. Clean the surface. Dirt, oil and loose paint stop the adhesive from bonding.
2. Let the surface dry fully.
3. Cut the tape to length with scissors or a utility knife.
4. Peel the backing and press the tape down, starting at one end.
5. Press hard along the whole strip, then press the edges again.

For stairs, place the strip near the front edge of the tread, where feet land first. Leave a small margin at each side so the tape does not hang over. On a long run of steps, cut one strip per tread and keep the spacing even.

For floor areas, mark the zone you want to cover, cut the tape to fit and press it down. A 2 in (5 cm) strip works well along a doorway or in front of a work bench.

Let the tape settle before heavy use. Press it again after the first day if any edge lifts.

Care and upkeep

Wipe the tape clean with a damp cloth. For mud or grit, wipe along the strip and let it air dry. Do not scrub with a stiff brush or use harsh cleaners, since both can wear down the textured surface.

Check the edges now and then. If a corner lifts, press it back down while the surface is dry. Replace the strip when the texture flattens and grip drops.

Why choose this tape

The textured surface gives traction without adding bulk. The adhesive backing means no nails, screws or tools. You cut it to the length you need, so one roll covers several steps or a mix of small spots.

Black keeps the strip low-key on dark stairs and clear on light ones. The same roll works inside the house and out on the porch, so you can handle a few projects without buying different products for each one.