Glow In The Dark Anti-Slip Stair Tape

$40.95

Black abrasive grit tape with a green glow-in-the-dark stripe that marks step edges in low light while giving shoes firm traction. Made for indoor and outdoor stair treads.

Expected delivery Thu, Nov 5 to Tue, Nov 10

Free shipping over $49
30-day returns

Shipping and returns

Free shipping over $49. Arrives in 7-12 days. Shipping times and costs per country

Not what you were looking for? Return it within 30 days of delivery. How returns work

Specifications

Material: Black abrasive grit surface with a green luminous stripe
Color: Black with a green stripe
Surface: Coarse anti-slip grit, luminous strip 0.47 in (1.2 cm) wide
Made for: Stair treads and steps indoors and outdoors
Sizes: 1.97 in x 8.2 ft (5 cm x 2.5 m) and 1.97 in x 16.4 ft (5 cm x 5 m)
Care: Wipe clean with a damp cloth

What this stair tape is

This is anti-slip tape made for stair treads and steps. The surface is a black abrasive grit that gives shoes something to grip, and a green luminous stripe runs along the tape so the step edge stays visible when the light is low. The luminous strip is 0.47 in (1.2 cm) wide.

The tape works indoors and outdoors. Use it on wooden steps, concrete stairs, deck stairs, basement steps and garage stairs. It is a simple way to mark the front edge of a step and add traction at the same time.

Sizes

Two lengths are available. Both are 1.97 in (5 cm) wide, which fits most standard stair tread edges.

Size	Width	Length
2 in x 8.2 ft	1.97 in (5 cm)	8.2 ft (2.5 m)
2 in x 16.4 ft	1.97 in (5 cm)	16.4 ft (5 m)

Measure the width of your steps and the number of steps you want to cover before you choose. The shorter roll suits a small set of steps or a few touch-up spots. The longer roll covers more steps in one run.

Color and finish

The tape is black with a green stripe. The black grit surface hides dirt well and blends with most stair materials. The green stripe is the luminous part, so it reads as a soft green line in dim light.

The grit is coarse by design. That texture is what creates the anti-slip grip underfoot. The stripe sits within the tape, so the glow and the grip are part of the same strip.

How to fit and use it

Clean the step surface. Remove dust, grease and loose finish so the adhesive can bond.
Let the surface dry fully before you apply the tape.
Cut the tape to the length you need with household scissors or a utility knife.
Peel the backing and press the tape onto the step, close to the front edge.
Press down firmly along the whole strip, then run your hand or a roller over it to set the bond.

For outdoor steps, apply the tape in dry conditions and give it time to settle before heavy use. On painted or sealed wood, test a small spot first if you plan to remove the tape later.

You can run the tape along the full width of each step or cut shorter strips for high-traffic spots. Keep the stripe facing up so it stays visible. If you use more than one strip on a step, line them up so the green stripe reads as one continuous line.

Care

Wipe the tape clean with a damp cloth. For heavier buildup, use a mild soap on the cloth and wipe again with clean water. Avoid harsh solvents and stiff brushes, which can wear down the grit and dull the stripe.

Check the edges now and then, especially on outdoor steps. Press down any lifted corner so the tape stays flat and keeps its grip.