EVA Grit Anti-Slip Stair Tape

What this anti-slip tape is

EVA Grit Anti-Slip Stair Tape is a roll of EVA tape with a textured grit surface. The grit gives your feet and hands something to grip, so smooth walking areas feel more secure underfoot. The tape is made for stairs, floors and bathrooms, and you can use it indoors or outdoors.

This is a simple, practical roll. You cut the length you need, peel the backing and press it down. There is no special tool and no mixing. The surface stays textured, and the tape wipes clean when it gets dusty or damp.

Sizes

Two widths are available, and both rolls are 197 in (500 cm) long. Pick the width that matches your step or the area you want to cover.

Because the roll is long, you can cut several strips from one roll. Measure your step first, then cut a strip that fits with a little room on each side.

Colors

Choose from three colors:

• Transparent: blends into light floors, tile and wood so the tape is less visible.
• Gray: a neutral tone that suits concrete, stone and most outdoor steps.
• Black: a strong contrast that makes the strip easy to see on light surfaces.

All three colors have the same grit surface and the same EVA build. The choice is about how much you want the strip to stand out.

Where to use it

Stairs are the main job. Cut a strip for each step and place it near the front edge, where feet land. This works on wood, tile, stone and concrete steps.

Floors come next. Use short strips in spots that get slick, such as a garage floor, a workshop area or a smooth hallway. Bathrooms are another good fit. Place strips in the shower, on the tub edge or on a bathroom floor that stays wet.

Outdoors, the tape suits porch steps, deck stairs, walkways and entry areas. The grit surface holds up to foot traffic and to weather changes. Just make sure the surface is clean and dry before you press the tape down.

How to apply it

1. Clean the surface. Remove dust, oil and loose grit. A dry surface holds the tape best.
2. Measure and cut. Cut the strip to the length you need with household scissors.
3. Peel and press. Peel the backing a little at a time and press the tape down as you go.
4. Smooth it out. Run your hand or a cloth over the strip to push out air bubbles.
5. Let it settle. Give the tape a little time to bond before heavy use.

For stairs, keep each strip straight and centered. For floors, mark the area first so the strips line up. If you use several strips, leave a small gap between them so water can drain.

Care

Wipe the tape clean with a damp cloth. For tougher spots, use a mild soap and water, then wipe dry. Avoid harsh scrubbing that could wear down the grit. Check the edges now and then and press down any spot that lifts. With basic care, the surface keeps its texture and the tape stays in place.

A note on fit

This tape is not a replacement for a loose stair tread or a broken step. It adds traction to a sound surface. If a step moves or a floor board is soft, fix that first, then add the tape.