GripGrid Non-Slip Furniture Tape

What it is and how it is made

GripGrid Non-Slip Furniture Tape is a roll of rubber foam with a self-adhesive backing. The top face has a textured grid pattern that adds grip between furniture and the floor. It is 0.24 in (6 mm) thick, so it cushions contact points and helps reduce movement and noise when chairs and tables slide. The tape is black, which blends with dark furniture legs and most floor finishes.

This is a simple, cut-to-size product. You measure the furniture foot, cut a piece from the roll and press it on. No tools are needed beyond scissors. The rubber foam is made for indoor use on furniture feet, chairs and tables.

Sizes and options

Each roll is 6.6 ft (2 m) long. You choose the width when you order. All three widths share the same 0.24 in (6 mm) thickness and the same grid texture.

A single roll covers many feet. For a set of four dining chairs, the 1.6 in (4.1 cm) width is a common pick. For a sofa or a heavy desk, the 2.4 in (6.1 cm) width gives more surface contact. The 0.8 in (2 cm) width suits slim metal legs and small stools.

Where it works

Use GripGrid tape indoors on furniture feet, chairs and tables. It fits wood, metal and plastic legs. Cut a square or circle slightly smaller than the foot so the tape does not peek out at the edges. Press it firmly and let the adhesive settle for a few minutes before you move the furniture.

Common spots:

• Dining chairs and kitchen chairs
• Desk and table legs
• Stools and small side tables
• Sofa and armchair feet
• Shelving and cabinet bases that rest on hard floors

The textured grid adds friction on tile, laminate, vinyl, hardwood and concrete. It also softens the contact point, which helps quiet the scrape of a chair pulled back from a table.

How to fit it

1. Clean the bottom of the furniture foot. Wipe away dust, grit and old adhesive.
2. Let the surface dry fully.
3. Cut a piece of tape to the shape you need. A square works on square feet, and a circle works on round feet.
4. Peel the backing paper from the self-adhesive side.
5. Press the tape onto the foot, grid side facing out.
6. Hold for a few seconds, then set the furniture down.

For uneven feet, cut a piece that covers the full contact area. If a leg has a small metal glide, the 0.8 in (2 cm) width wraps or caps it neatly. For heavy pieces, use the 2.4 in (6.1 cm) width and press it on with steady pressure.

Care and handling

Wipe the tape with a damp cloth when it collects dust. Avoid soaking it, since the foam holds water. Check the tape every few months on chairs that move daily. If an edge lifts, peel the piece off, clean the foot again and apply a fresh strip from the roll.

Store the unused roll flat in a dry spot. Keep the backing paper on the part you have not cut yet so the adhesive stays clean. Rubber foam can harden over time, so use the roll within a reasonable period after opening.

What you get

The box contains 1 roll of tape in the width you select. Each roll is 6.6 ft (2 m) long and 0.24 in (6 mm) thick. Color is black. The tape is made for indoor furniture feet, chairs and tables.