Soft Stripe Non-Slip Stair Treads

What these stair tread mats are

Soft Stripe Non-Slip Stair Treads are mats that rest on the steps of an indoor staircase. The top is a soft striped woven fabric made of 100% polyester. Underneath, a self-adhesive non-slip vinyl backing grips the step and helps hold the mat in place.

The woven surface gives bare feet and socks a softer place to land than bare wood or tile. The striped pattern is simple and quiet, so it works with many kinds of interior decor.

These treads are made for stairs indoors. They are not outdoor mats and they are not bath mats.

Sizes and fit

Each tread measures 30 x 8 in (76 x 20 cm). The width is the part that matters most when you check your stairs.

The mat is designed for steps that are 30 in (76 cm) wide or wider. If your step is wider than the mat, you can center one tread on the step or place two side by side. Measure your step depth as well, so the 8 in (20 cm) depth sits comfortably on the tread without hanging over the nose of the step.

Colors

You pick the color when you order. The options are:

• Brown
• Dark gray
• Black
• Light gray

Brown and the two grays read as softer, warmer tones on wood. Black gives a deeper, more defined line on each step. All four colors use the same woven striped surface and the same vinyl backing.

How to fit and use them

1. Clean the step. Wipe away dust, crumbs and any oily residue, then let the surface dry fully.
2. Check the fit. Set the tread in place before you peel anything. The mat should sit flat on the step with the striped side facing up.
3. Peel and press. Remove the backing film and press the mat down from the center outward. Run your hand along the edges so the vinyl makes full contact.
4. Repeat on each step. Keep the spacing even from step to step for a tidy look.

A few notes that help the backing hold:

• The vinyl backing is self-adhesive, so it works best on smooth, clean, dry surfaces such as sealed wood, laminate, tile and painted steps.
• Press the mat down again after the first day or two of foot traffic.
• If you need to move a tread, lift it slowly from one corner rather than pulling it straight up.
• These treads are made for indoor stairs. Keep them out of standing water and away from outdoor weather.

Care

These stair tread mats are machine washable. Before washing, peel each mat off the step. Follow the care instructions on the label, and use a gentle cycle with cold or lukewarm water. Skip fabric softener and bleach.

Let the mats air dry flat. Do not put them in a hot dryer, because heat can affect the vinyl backing. Once the mats and the steps are completely dry, press them back down.

For quick touch-ups between washes, vacuum the woven surface or shake the mat out. Spot clean small marks with a damp cloth and mild soap, then let the mat dry fully before you put it back on the step.

Why shoppers choose woven stair treads

Stairs get a lot of traffic, and bare wood steps can feel hard and slick underfoot. A woven tread adds a soft layer and a non-slip base at the same time. The polyester surface is smooth enough to walk on in socks and sturdy enough for daily use.

The low profile keeps the mat close to the step, so doors and feet clear it easily. Because each tread is a separate mat, you can cover only the steps you use most, or run them the full length of the staircase. If one mat gets dirty, you can wash that single mat instead of pulling up the whole set.

Measure your steps, choose your color, and set the treads in place. That is all it takes to make an indoor staircase softer and less slippery underfoot.